Hello everyone,
I am new to TinyOS. I am using micaz ( MPR2400) hardware board with
programmer MIB520. When running simple blink application using command make
"micaz install mib520,/dev/ttyUSB0", i got an error:
mkdir -p build/micaz
compiling BlinkAppC to a micaz binary
ncc -o build/micaz/main.exe -Os -fnesc-separator=__ -Wall -Wshadow
-Wnesc-all -target=micaz -fnesc-cfile=build/micaz/app.c -board=micasb
-DDEFINED_TOS_AM_GROUP=0x22 --param max-inline-insns-single=100000
-DIDENT_APPNAME=\"BlinkAppC\" -DIDENT_USERNAME=\"iist\"
-DIDENT_HOSTNAME=\"iist\" -DIDENT_USERHASH=0x6803a78cL
-DIDENT_TIMESTAMP=0x53db968fL -DIDENT_UIDHASH=0x38879a0eL
-fnesc-dump=wiring -fnesc-dump='interfaces(!abstract())'
-fnesc-dump='referenced(interfacedefs, components)'
-fnesc-dumpfile=build/micaz/wiring-check.xml BlinkAppC.nc -lm
compiled BlinkAppC to build/micaz/main.exe
2044 bytes in ROM
51 bytes in RAM
avr-objcopy --output-target=srec build/micaz/main.exe build/micaz/main.srec
avr-objcopy --output-target=ihex build/micaz/main.exe build/micaz/main.ihex
writing TOS image
cp build/micaz/main.srec build/micaz/main.srec.out
installing micaz binary using mib510
uisp -dprog=mib510 -dserial=/dev/ttyUSB0 --wr_fuse_h=0xd9 -dpart=ATmega128
--wr_fuse_e=ff --erase --upload if=build/micaz/main.srec.out --verify
Firmware Version: 1.8
Atmel AVR similar to the ATmega103 is found.
Uploading: flash
Verifying: flash
Cannot write high fuse bits on this device.
Fuse High Byte set to 0xd9
Cannot read extended fuse bits on this device.
Fuse Extended Byte set to 0xff
rm -f build/micaz/main.exe.out build/micaz/main.srec.out
The above says it is detecting atmel 128 in the board but i think there is
some fuse problems. Please help!
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
