On Wed, 25 May 2022 17:15:09 -0400 Gary Grebus <g...@grebus.com> wrote:
> On 5/25/22 14:07, Ed wrote: > > I use a ic-7300 and have it set to use USB0, but I get no rig > > control. > > > > Not sure how to correct this, the 7300 uses a symlink to USB0, so > > how do I get this to work ? > > > > /dev/serial/by-id/usb-Silicon_Labs_CP2102_USB_to_UART_Bridge > > +_Controller_IC-7300_02038316-if00-port0 > > > > That should be a symlink to the actual tty device. On my system it > is /dev/ttyUSB0. > > > pi@pi2:~ $ ls -l /dev/serial/by-id > total 0 > ... > lrwxrwxrwx 1 root root 13 May 17 10:50 > usb-Silicon_Labs_CP2102_USB_to_UART_Bridge_Controller_IC-7300_02034059-if00-port0 > > -> ../../ttyUSB0 > > So in logcfg.dat: > > RIGMODEL=373 > RIGPORT=/dev/ttyUSB0 > RIGSPEED=19200 Same as here,except this error in tlf Rignumber is 373 Rig speed is 19200 Trying to start rig ctrl rig_open: error here is my setup RIGMODEL=373 RIGSPEED=19200 RIGPORT=/dev/ttyUSB0 I have no experience with udev and it is going to be a challange Ed W3NR