The output of eg "w" is only used by tmux when w exits, tmux does not wait for it
On 18 Aug 2016 4:52 p.m., "Uwe Werler" <[email protected]> wrote: On 18. Aug 16:41:42, Nicholas Marriott wrote: > the output is only used when the command finishes I don't understand. The command runs fine if I call it the second time. And yes, it get's finished. > > > > On Thu, Aug 18, 2016 at 05:29:33PM +0200, Uwe Werler wrote: > > Hello list, > > > > if I run a shell command from within status I get at the first time the > > following error message: <'%s' not ready> > > > > For example run from status: > > > > display-message -p '#(w)' > > <'w' not ready> > > > > The second time I run the command it works. The same happens by inserting a > > command in the status line. > > > > Any hints? > > > > Thanks in advance! > > > > Regards Uwe > > > > PS: running tmux on OpenBSD -current from 12.08.2016 > > > > -- > > > > -- > > You received this message because you are subscribed to the Google Groups "tmux-users" group. > > To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. > > To post to this group, send an email to [email protected]. > > For more options, visit https://groups.google.com/d/optout. -- -- You received this message because you are subscribed to the Google Groups "tmux-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
