I am trying to get my apache 2.0.40 running with jk. I tried jk 2.0.43 but get error: mod_jk.c is not compatible with this version. However, I cannot locate mod_jk.c on my system, only mod_jk.so. The documentation for jk 2.0 says it can only be used with Apache 2.0.42.
Any suggestions? thanks, Phil Campagine ----- Original Message ----- From: "Manavendra Gupta" <[EMAIL PROTECTED]> To: "Tomcat Users List" <[EMAIL PROTECTED]> Sent: Saturday, January 18, 2003 4:46 PM Subject: Common problems faced with tomcat configuration > Hi, > > In the past several months that I have been in the list, I have seen the > following problems faced commonly by the users (new or old): > > 1. Configuring DataSource with tomcat > 2. Configuring tomcat to run with apache (using AJP or JK2) > > I would like to know if there is anything being done to make it easier for > the new users to get around these bottlenecks. Also, I am sure there are a > number of experienced users on this list who have successfully done the two > things above, and I would request them to post the steps for a successful > configuration. We can then collaborate and post a better documentation to > configure these. > > Finally, I would also like other users to contribute to this (small) list > above, the problems they think have been faced commonly and repititively by > tomcat users, so that we can strengthen the documentation for those too. > > Thanks, > Manav. > > > -- > To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]> > For additional commands, e-mail: <mailto:[EMAIL PROTECTED]> > -- To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]> For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>