Hi Tom ! thanks for your quick reply .... I have tried the new 2.0.88. the built is still based on a more same old driver (3c59x.c:v0.99Q 5/16/2000 ... ) but it _DOES_ work.
thanks a lot ! I tried the cardbus.o yesterday ... but insmod gave me some unresolved symbol for find_io_region, undo_irq, try_irq and find_mem_region. (I have the same result w/ the 2.0.88) fab ----- Original Message ----- From: "Tom Oehser" <[EMAIL PROTECTED]> To: "Fabrice LABORIE" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Sunday, April 28, 2002 7:30 PM Subject: Re: [tomsrtbt] 3c575 ifconfig oops / segmentation fault with 2.0.85 > > I have not used or tried 3c575. What I can do is try rebuilding the > pcmcia stuff, the kernel has been rebuild since I built the pcmcia > stuff which could have broken something (though probably not). Try > looking for a newer one in a couple of days. It may be also you need > cardbus.o in addition to cb_enabler.o? Try that too. -Tom > > On Sun, 28 Apr 2002, Fabrice LABORIE wrote: > > > Date: Sun, 28 Apr 2002 19:21:17 +0300 > > From: Fabrice LABORIE <[EMAIL PROTECTED]> > > To: [EMAIL PROTECTED] > > Subject: [tomsrtbt] 3c575 ifconfig oops / segmentation fault with 2.0.85 > > > > Hi ! > > > > I am having some problems here with a ThinkPad 600E with a 3com 3c575 card > > (3CCFE575CT) > > > > I found the > > v2-add-ons/pcmcia/3c575_cb.o.bz2 and > > v2-add-ons/pcmcia/cb_enabler.o.bz2 > > modules ... > > > > I changed the pcmcia/config so to get the card recognized. > > > > 1) > > whenever I was inserting the card, I was getting an error > > (kernel: Unable to handle kernel paging request at virtual address... > > + oops !) > > > > I had to remove the "dhcp--" from the ./network script. > > the error went away... > > > > 2) if I try to configure the card manually , I still get an "oops" > > as soon as I use a "ifconfig eth0 xx.xx.xx.xx" > > "I still get an Unable to handle kernel paging request ...." :( > > > > I am stuck.... > > > > I looked on the list archive but I find an related matter... Anybody has > > seen this ? > > > > > > Ok .. maybe I am doing something wrong ... because after spending some time > > looking > > around, it seems that the 3c575_cb.o is actually loading a 3c59x driver but > > older > > than the one that comes with built-in with the kernel ... > > (in kernel I think there is 3x59x.c 18Feb01 , where as the 3c575_cb module > > seems to be 3x59x.c:0.99Q 5/16/2000 ) > > > > Has Anyone built a 3c575_cb.o from a more recent 3x59x.c file ??? > > > > Or should I try to use the kernel built-in driver?? ( I read the manual > > of pcmcia but I didn't see how to bind to a buil-in kernel driver instead of > > a module ??) > > > > > > as always, > > any help is appreciated ! > > > > fab > > > > > >
