My TS-940 has the same setup but not the TS-950SD and many other rigs. I use a toggle switch an high isolation DIP relay to do the control, under $5 in parts.
Carl KM1H ----- Original Message ----- From: "Rik van Riel" <[email protected]> To: <[email protected]> Sent: Thursday, April 21, 2011 2:52 PM Subject: Re: Topband: What are folks using for a T/R relay in the shack, to switch between beverage and xmit antennas? > On 04/21/2011 10:08 AM, Mark Lunday wrote: >> I see some stuff out there from DX Engineering, but before I buy I wanted >> to >> check with others. Thanks > > On my old TS-930, I plan to use the transverter (XVTR) > plug on the back of the radio to feed in the RX antenna > separately. > > It has a place where the TX antenna's received signal > goes out, and gets back looped in to the radio's > receiver ... or not, you can intercept and change it :) > > -- > All rights reversed. > _______________________________________________ > UR RST IS ... ... ..9 QSB QSB - hw? BK _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK
