Typical switch-mode noise. Over the years, I have had to identify several of these noise sources from within my own home as well as neighbors. Keep in mind this is a different type of noise to localize than that produced by power lines.
The first step involves powering down your hone, one circuit at a time, and defeating battery-back systems like security. It's most helpful to power the rig by battery during testing. If the switching noise stops as you deactivate breakers, then you know the noise is on your property and you'll need to investigate appliances on the affected branch circuit. If the noise remains, you'll need to identify the direction, likely coming from a neighbor who has recently added a switch-mode appliance. I use a directional loop antenna, SDR-IQ receiver, and notebook PC to document the noise with screen captures while on foot. Most of the time, I can triangulate the source with the loop. This can save a lot of time. The usual question arises: What could it be? It can be many things and you need to investigate rather than ponder the question. For example, here's a list I'm recalling from memory of devices belonging to neighbors that I've had to either replace or add RFI/EMI chokes to cabling: Neighbor's micro-refrigerator, Neighbor's PC power supply, Neighbor's scooter charger. In my own home: Many wall warts, Sony Playstation II, Microwave oven, Toshiba DVD player. Each one of these devices produced a typical switching noise signature. Noise "bumps" that show up on the panadpater every 40-80 kHz or so depending on the device's switching frequency. In short, anything with a switch-mode supply is a potential unintentional radiator. If the neighbor's device is relatively inexpensive, I'll just replace it on my dime. If it's unusual or expensive, then I'll do my best to work with the neighbor to add common mode choking. Most of my neighbors are willing to work with me. Not all, but most. Advice: try to work with your neighbors before pulling the FCC or ARRL trigger. They may view it as threatening action even through they are most certainly under a duty to mitigate the interference. If you can't resolve the issue to your satisfaction, read the "next steps" material on the ARRL's website. Paul, W9AC ----- Original Message ----- From: "Mike Greenway" <[email protected]> To: "TOPBAND" <[email protected]> Sent: Tuesday, November 01, 2011 8:22 AM Subject: Topband: RFI > This year I am encountering a hash noise that repeats about every 66 to 70 > Khz. It is maybe 20 or 25 khz wide with a peak at the center. Sound like > the background noise is just increasing as you tune across it. Has anyone > identified something like this? 73 Mike K4PI > _______________________________________________ > UR RST IS ... ... ..9 QSB QSB - hw? BK _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK
