With AT&T Uverse I had the experience of adding common mode chokes (#31 ferrite) on a long run of cat 5 and having it knock down the desired signal. The cat 5 is not all that well balanced, and putting the hurts on the unbalance also knocks down the main signal which was marginal to start with.
In the end we had to redo the layout so the long runs of cat 5 had ethernet on them instead of Uverse's 147 kHz through 7.9 MHz VDSL...AND...change out the 2Wire 3800 gateway to a 3801...AND...replace the entire buried loop from the pole into the house (550') and its umpteen splices over the years with a continuous piece of modern shielded pairs. In the end the little insertion filters they have were better than anything I could wind around the 3801. I use the ferrite around the in-house ethernet cat5 on the TV and PC ends. There was a similar problem with the neighbor. He has a 2Wire 3801 now as well. He also had to have his loop from the pole replaced. I put a bunch of ferrite on his TV side as well. When I'm on 160 QRO, we both have a lot of corrected errors to start and then the modem starts adjusting bit rates on individual VDSL carriers or locking them out. After a while there won't even be corrected errors. The 3801 has a much better protocol than the 3800, and has hugely more buffering for handling a flood of errors at onset of interference. But don't see any hits on TV, internet or phone. Some or all of these problems will need to be solved at xDSL sites with interference. Quality of modem/gateway definitely can be a problem. 73, Guy _______________________________________________ UR RST IS ... ... ..9 QSB QSB - hw? BK