On Sun, Nov 18, 2012 at 5:10 PM, Mike Waters <[email protected]> wrote:
> Hi Jorge, > > If your Beverage is bidirectional, the reflection transformer ground is > more important. If just a single wire, less so. > > I use radials. See > http://www.w0btu.com/Beverage_antennas.html#Beverage_antenna_grounds > and > http://www.w8ji.com/ground_resistance_measurements.htm > > 73, Mike > www.w0btu.com > > > On Sun, Nov 18, 2012 at 4:55 PM, Jorge Diez - CX6VM <[email protected] > > wrote: > >> Thanks Mike**** >> >> ** ** >> >> Do you think adding two radials at the end rod will help to improve RX?** >> ** >> >> ** ** >> >> Actually I have two 750ft long beverage for USA and Europe and they are >> noise. I add a third tower and now my Europe beverage is going very near my >> 200ft guys anchor. **** >> >> ** ** >> >> This new beverage I want to put is very far of my towers. I want to see >> if it hear better or if it´s the same.**** >> >> ** ** >> >> 73,**** >> >> Jorge**** >> >> CX6VM/CW5W**** >> >> ** ** >> >> *De:* Mike Waters [mailto:[email protected]] >> *Enviado el:* domingo, 18 de noviembre de 2012 20:39 >> *Para:* Jorge Diez - CX6VM; topband >> *Asunto:* Re: Topband: beverage layout**** >> >> ** ** >> >> Hi Jorge, >> >> Beverages don't have to be either straight or level. >> >> It would be better if it was straighter, but if that's all you can do at >> your QTH then by all means put it up that way. >> >> My "Europe/Australia" Beverage has a 15 degree bend in it and hears >> great. I didn't model your description, but I think you will be happy with >> the way it works. >> >> 73, Mike >> http://www.w0btu.com/Beverage_antennas.html**** >> >> On Sun, Nov 18, 2012 at 4:25 PM, Jorge Diez - CX6VM < >> [email protected]> wrote:**** >> >> Hello >> >> Is there any problem if a beverage is not 100% on the same direction? >> >> Start at feed point with 70 ft going to 0 degrees and then 830 ft going >> to 40 degrees >> >> Will be any problem with this or will be OK for a 40 degrees (Europe) >> beverage**** >> >> ** ** >> > > _______________________________________________ Topband reflector - [email protected]
