Hello Alex, In your case, the "dry" soil state make the antenna impedance about 30ohms. In the "wet" soil state, the ground conductivity improves minimizing the losses. The antenna impedancebecomes about 17ohms, much closer to the ideal 11ohms (in your case).
Solution: Minimize ground losses. How? With an RF current meter (such: http://www.w8ji.com/building_a_current_meter.htm) start from the scratch to re-arrange the radials for less ground loss. Anyhow, keep in mind that the "wet" soil state antenna impedance is better then the initial one. I know you should use an impedance adapter but this is the way it works. Good luck. 73 de YO3FFF Cristi ________________________________ From: ALEXEY OGORODOV <[email protected]> To: [email protected] Sent: Thursday, January 31, 2013 4:37 AM Subject: Topband: inverted L issues Hello, Right to the point. At HD2A we installed an Inverted L with the following dimensions: vertical portion 16m horizontal portion 26m. The horizontal wire goes with slightly upward with with its end at 19m above the gound. The ground system - 4 x 6ft ground rods at the base - 34 x 42odd m radials on the ground No matching device is used. Fed directly with RG8 coax. The SWR was at 1.5 to 1.8 on 1.832 now it is 3:1 at the same frequency with no visible alterations to the antenna except the rain season. The question: what could cause the SWR increment? any suggestions to bring it down and keep it relatively stable. Thanks in advance, Alberto, Alex HD2A Team _________________ Topband Reflector _________________ Topband Reflector
