I went exploring with a direction finding antenna and my rig on batteries along the street, and the 120Hz impulse noise near the power lines on the street is far far worse than it is up the driveway at my house. But unable to pin down to any one pole.
The 120Hz noise I have is worst on 40M and 30M... I suppose it's possible it's an arcing source on a 50 foot wire, that would be about a half wavelength on those bands, and that's why its worst in that range. But that's all hypothetical until it's tracked down and fixed! Tim N3QE ________________________________________ From: Topband [[email protected]] on behalf of Jim Brown [[email protected]] Sent: Thursday, December 26, 2013 12:22 PM To: [email protected] Subject: Re: Topband: 160 condx last night On 12/26/2013 6:22 AM, Shoppa, Tim wrote: > If anyone has any insight for how 120Hz impulse noise can just disappear > below a certain frequency, that might help me find it. Several logical reasons that can happen. 1) The antenna radiating it is more effective at higher frequencies. 2) The directivity of your RX antennas with respect to the source is such that they reject the noise on those lower bands. 3) It's not broadband, because it's electronically generated. This is true of virtually all switching power supplies, and many electronic sources. The noise from my SteppIR controller and its switching PSU wipe out some bands and not others. The PSU is worst on 12M, bad on the bands around it, but not so bad lower in frequency. Now that I've replaced it with a linear supply, I hear the controller on the160M that's 25 ft away, so I have to turn it off when I want to work 160M. 4) The source you're hearing on 40M might not have been active when you were on 160 last night. 73, Jim K9YC _________________ Topband Reflector Archives - http://www.contesting.com/_topband _________________ Topband Reflector Archives - http://www.contesting.com/_topband
