All
Topband list If you've followed my efforts to shunt feed my Skyneedle tower you'll know that I settled with a tap point of 67' and 30" or so of spacing with my feed point reading 42 + j0 ohms. This reading was taken at the interior of my 20 x 30 x 8" steel Hoffman enclosure with the variable cap located outside the enclosure sitting on a plastic 5 gal jug. The output of the variable cap fed into a ceramic feed thru insulator thru the panel to a copper "L" bracket that mounts the SO 239 connector that I hooked my coax cable to. Since then I've moved the variable capacitor inside the panel and mounted it to a ¾" think Plexiglas sheet mounted to the back plane with nylon bolts and washers. There is a 1" air gap between the Plexiglas and the backplane. I now have seen the 42+j0 ohms change to 45 - j11 ohms...that's the lowest reactance I can tune the capacitor for. Not really sure if its +j11 ohms or - j11 ohms but I assume if the reading was + j11 I could continue to tune it out with the capacitor but I cant. Does the capacitor not play well with a steel enclosure? The other strange situation I'm experiencing is when I connect my Array Solutions static bleed choke to the feed thru insulator at the outside of the panel to ground the resonant frequency jumps to 2.014 MHz at 25 +j0 ohms...remove it entirely and I'm back to my 45 - j11 ohms. I use 1 meg ohm from the feed point to ground on my other verticals with NO change in MFJ analyzer readings. Any comments from the list on these problems? Thanks Carl AG6X _________________ Topband Reflector Archives - http://www.contesting.com/_topband
