Hi Marsh I agree. This is a basic technique and I’ve used it for decades. While stations butt heads on the “zero beat” frequency I transmit 100 to 200 Hz above and usually make the contact. During the ARRL 160 Meter contest there were times I was transmitting 300 to 400 Hz high to make the contact. If your station can project power than you can butt heads; those of us that have more modest stations need to do things differently. This technique works well for contests and DXpeditions (although thankfully most dxps run split).
Running stations and using a very narrow filter is asking for problems. I typically use 250 Hz and make sure my RIT is well oiled. If a station successfully encroaches on my run frequency such that I have to go to (say) a 100 Hz filter, I find another frequency – there’s plenty of real-estate on 160M. 73 Mark K3MSB On Dec 7, 2017 12:07 PM, <ma...@ka5m.net> wrote: I respectfully disagree with Don Kirk. My experience has been different. I don't how many pileups I've broken quickly - where the station I'm trying to work is operating simplex - by going split and transmitting a few Hz above or below "zero beat". The operator at the other end is trying to copy a callsign, and if everybody is "zero beat" it makes it very difficult to copy anybody. Anything you can do to make your signal "stand out" or differentiate it from the crowd makes it easier for the station you're trying to work. (Also speeding up or slowing down a few WPM sometimes helps.) Someone taught me this a long time ago, and it works. He's worked a lot of good DX in the last sixty (60) years or so. 73, Marsh, KA5M -----Original Message----- From: Topband [mailto:topband-boun...@contesting.com] On Behalf Of Don Kirk Sent: Thursday, December 7, 2017 10:17 AM To: MR TREVOR DUNNE <ei2...@eircom.net> Cc: g...@ka1j.com; topband List <topband@contesting.com> Subject: Re: Topband: ARRL 160 Hi Trevor, Besides your TX antenna, another issue I have observed over the years is the importance of being as close to zero beat as possible. The modern HF radios offer very narrow RX filtering options, and during very crowded band conditions most of the stations are running very tight filters and I find that if I'm off zero beat by much more than 100 hertz I'm often not heard. I use a very old HF rig and run a 500 hertz filter, and found myself having to continuously adjust my TX frequency until I popped into the passband of the station I was trying to work (very difficult to zero beat my radio in any kind of timely fashion). I finally installed an audio filter (Hi-Per Mite) with 200 Hz bandwidth and this has basically fixed my problem (99.9 percent improvement). Previously it was very frustrating hearing a station 20 dB over S9 that could not hear me. I originally thought they were using an RX antenna not pointed my direction, but most often I was just not in their RX passband. Just another possibility. 73, Don (wd8dsb) _________________ Topband Reflector Archives - http://www.contesting.com/_topband _________________ Topband Reflector Archives - http://www.contesting.com/_topband