I agree Rick.. Too “clever” but just enough to fool me.. once. After I get the new coil ready (Using brass hardware to replace the stainless bolts also) and find the sweet spot again using the proper coil clips, I will SOLDER the clips onto the copper at that time without shorting out any other coil turns. Since this is a series coil at the base, I will use a shunt coil to match the swr.. I hope that is what I am going to do and not blow up something else .
From: Richard (Rick) Karlquist Sent: Monday, November 16, 2020 10:02 AM To: Tim Shoppa; Larry-k1uo Cc: [email protected] Subject: Re: Topband: Stainless Steel for coil taps. I _________________ Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
