I am writing a translator that translates reservoir model specifications to OWL in N3. The translator writes the resultant N3 files into a TBC works space, so that I can easily view the results using TBC for debugging. I routinely run into problems where TBC will not open the generated N3 files and will mark them with a red x. This happens even if I close the N3 files I was inspecting before regenerating the N3 files and even after doing a refresh (although if you "close all" this will work, see below).
When viewing the files in a text editor in TBC, synchronization works as expected as TBC will let you know when files have been updated and prompt you on whether to update the viewed file or not.) I have found 2 work-arounds 1) cause TBC to reload after generating new N3 files, 2) select "close all" to close all open N3 files and close folder trees in the workspace before re-generating the N3 files, and then issue a refresh on the topmost folder before viewing the generated files. Work-around 1 works the best as when TBC comes back up, it opens all of the models that I had been looking at, so there is no need to re-open them. The refresh does not seem to work as I had expected and reloading TBC every time seems a little extreme. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "TopBraid Composer Users" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/topbraid-composer-users?hl=en -~----------~----~----~----~------~----~------~--~---
