I have been trying for weeks now to improve my connectivity by connecting my Touch wired vs. wirelessly to LMS 7.2. Wireless connects fine and works well except for occasional dropouts. Reading through the Touch Toolbox (most of which is far too esoteric for me to even think of trying) I decided to try to improve things by connect with an ethernet cable to some kind of wireless bridge. I tried the Amped Wireless Repeater for a week but could never get the Touch to make a wired connection to my network. When the Touch is connected with ethernet to my router, no problem, it connects immediately. I thought the Repeater was bad so returned it. This week I tried a Netgear Powerline box setup--two little modules that plug into the wall and have ethernet ports. The little boxes can communicate to one another, but again, when I plug the Touch into one with a cable, the Touch cannot connect to my network. I tried entering my network settings in by hand but again no luck. What is going on? Why can't my Touch recognize my network when it's asked to connect via ethernet cable? Once I switch the Touch option to "connect via wireless," no problem, I'm up and running. And again, the Touch connects fine via ethernet to my router. It just won't sync up with a bridge. Tell me what I'm doing wrong!
-- sc53 Living Room ~ Touch > Benchmark DAC > Audio Research CA-2 > ProAc D15 Bedroom ~ Boom Kitchen ~ SB3 > NAD 747 > ATC SCM 12 Listening Room ~ SB3 > Electrocompaniet ECD 1 DAC > Electrocompaniet ECI 3 > Genesis 500 ------------------------------------------------------------------------ sc53's Profile: http://forums.slimdevices.com/member.php?userid=8690 View this thread: http://forums.slimdevices.com/showthread.php?t=92992 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
