Thank you guys, problem (sort of) solved. The PSU is fine, I drove the SB Classic with it and all was good. Voltage measured at 4.91 which is within limits.
With the helpful advice from John Swenson's article from the link posted by bpa, I managed to open the unit quite easily. Most difficult part was find drivers that matched the Touch's screws (T10 Torque driver for the foot, small Posidrive for the casing screws) and looked in dreaded fear at the inside. While still pondering the best way forward, I had one of my rear brainwaves which was to plug the PSU in and try measure the voltage whilst on load. Easier said than done, I had not yet disconnected the PC Flexicables nor removed the PCB board and while still looking for a suitable voltage measuring point I noticed the unit had come back to life again. I gently shook the unit, probed to find a possible dry joint (yes, as if that is even possible!) and it remained on. Put it all back together and listening to Boss Radio now as I type this :) So although I cannot report on what the problem is/was, as long as it is working I am quite happy! I just love this unit in spite of its quirks: (See from reply #37 onwards) https://forums.slimdevices.com/showthread.php?111647-SB-Touch-and-Internet-Radio/page4 -Eric ------------------------------------------------------------------------ ews2k's Profile: http://forums.slimdevices.com/member.php?userid=69845 View this thread: http://forums.slimdevices.com/showthread.php?t=112323 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
