On 4月20日, 上午10时51分, Noah Kantrowitz <[EMAIL PROTECTED]> wrote:
> [EMAIL PROTECTED] wrote:
> > Hi all,
>
> > I'm write a program to control my WL-500gP for some specific
> > application. when I use the WLC_SCAN command with the paramter type
> > wl_scan_param_t* (which assigned by broadcom ioctl document), the
> > command did not work. After some work I found the correct paramter
> > type should be wl_ssid_t*...but I found in the OpenWrt source codes
> > (file: wlcompat.c), you used the wl_scan_param_t* as the paramter
> > type, and I think it must get work in your program. So, I think there
> > may be some problem in my code, can I get some information about the
> > WLC_SCAN here?
>
> You have the wrong list, this is for the development of the Trac project
> management software. Chances are you are looking at a project that just
> uses Trac to run their development.
>
> --Noah
>
I am sorry about this mistake...
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "Trac
Development" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [EMAIL PROTECTED]
For more options, visit this group at
http://groups.google.com/group/trac-dev?hl=en
-~----------~----~----~----~------~----~------~--~---
