I sort of ran into the same thing. If the computer sees it, and the
configuration program opens, if you do not see a Firmware number at
the top of the configuration, then run update firmware. In other
words, with mine, the unit came "loaded" blank, and I had to use the
update firmware to get to a starting point to program the unit. After
that, all was fine. I haven't seen this documented elsewhere.
Gerry
W5LCY
On Jun 30, 2009, at 8:51 AM, kc0nro wrote:
All,
Just got my OTm2 last night and am still trying to get connected to
the booger and configure it...
I have tried every thing I can think of. otwincfg and hyper
terminal...many different baud rates, flow control, etc. I can't
seem to get the PC talking to the unit.
FYI, I am using a gender changer on the end of my serial cable to
hook to the OTm2's serial port.
Anyone have any ideas?
Many thanks,
JOHN
