Try connecting with a terminal program and do a DUMP command or something that produces a lot of output, and see if you get any glitches. It might be a bad solder joint on the ST202 chip or something.
Scott ml_mn wrote: > > > I use a USB to serial > > it has been working and if i conenct my friends OT2 it works fine. > > --- In [email protected] <mailto:tracker2%40yahoogroups.com>, > Scott Miller <sc...@...> wrote: > > > > It could be a serial comm problem - are you using a USB adapter? When > > you enter diagnostic mode it starts constantly sending commands to check > > ADC readings, and it tends to be more sensitive to timing problems in > > USB to serial devices. > > > > Scott > > > > ml_mn wrote: > > > > > > > > > Hi > > > > > > When i try to access the tuning/diagnostics in otwincfg the OT2 leave > > > prog/config mode and i have to restart otwincfg > > > > > > I can read/reflash the modem with new firmware or change config > parameters > > > > > > Any ide ? > > > > > > TIA > > > Mike > > > > > > > > > >
