Hello All, I'm trying to set up a Tracker2 OT2m to a NUVI 350 and when
I power everything up the radio goes into TX and stays there so I obviously
have something wrong. For a starter I am running an ICOM
IC-W32A and using a ICOM type speaker MIC cable from Argent Data
Systems. I connected red speaker wire to serial pin 5, white MIC wire to pin 1,
blue PTT wire to pin 3 and black ground to pin 6.
Also, I was not sure about the need to connect the HT jumper in the
Tracker2 but it is connected. I might have something wrong in the
otwincfg set up (??). Any advice or correction will be much appreciated.
TNX, Jim / KW9B
