Larry, Thanks for you suggestions. While the sequence looks like the power up sequence is it slower by about 2x. Also it doesn't start until I select "Connect" in otwincfg. I've also verified that the power is good. In otwincfg when I check "Erase device and load new firmware" and then select "Connect" nothing other than the periodic LED sequence I've already described occurs, so no success trying to load new firmware.
Thanks again Tim - KB4PZO --- In [email protected], "k7ybz" <k7...@...> wrote: > > The LEDs flashing like that is indicative of power being applied then > removed. That is the blinking order of the LEDs at boot up. You might have an > intermittent or just plan bad power connection. > > The rest of your procedures looks normal. However, you could also try to > upload firmware to the OT2 in case what is there has been corrupted. You can > see that option on the Tracker Connection window. Just check the box and > follow the instructions after selecting 'Connect". > > Larry > K7YBZ > > --- In [email protected], "kb4pzo" <kb4pzo@> wrote: > > > > I just got my Tracker2 OT2m today and can't communicate with it to set the > > configuration. Any suggestions would be greatly appreciated. > > > > I'm using a USB to Serial Port converter. I'm running MS Vista Home > > Premium but have also tried running Otwincfg in XP emulation mode. The > > results I've gotten are as follows: > > > > Tera Term > > + Verified the USB-serial converter and null-modem serial cable are working > > by successfully talking to a TT4 > > + Tried various baud rates 4800 (also 2400, 9600, 19,200) with no results, > > OT2m does not respond to several "Returns" > > + One data point is that at 4800 when I turn off the Tracker I see garbage > > characters, similar to what you see when the baud rate is set incorrectly. > > > > otwincfg > > + Select COM Port, press Connect, Turn on Tracker2 > > + About every 13 seconds Tracker blinks LEDs in order (ACT, TX, RX) in > > quick succession > > + "Connect to tracker" window continues to be shown with "Connect" button > > grey-ed out and message "Ready to connect, Please reset tracker now." > > displayed > > > > 73, > > Tim > > KB4PZO > > >
