Worked perfect today on our trip. Thanks again.
Dan
--- In [email protected], "dan" <wd0...@...> wrote:
>
> Thanks Alan. Over the last two evenings you guys have really helped me out. I
> must admit I was a bit intimidated by some of the posts I had been reading
> before I posed my problem. But, you stooped right down to my level and gave
> me a lift. I feel I have learned a lot in two nights. Thanks everyone and I
> will keep reading your posts here.
> Dan
>
> --- In [email protected], "Alan" <alan@> wrote:
> >
> > Dan,
> > Looks like it settled down, a couple beacons 10 minutes apart:-)
> > I think your scared the demon's out of your OT2:-)
> >
> > Hope you and Teri have a safe trip,
> > Alan
> >
> >
> >
> > --- In [email protected], "dan" <wd0afq@> wrote:
> > >
> > > Ok Alan, I downloaded it from your link and reloaded my tracker. Also
> > > saved it. Thanks. I took the low voltage out of my program. I am going to
> > > stop tomorrow and get some 12 gauge wire to run to the radio and put it
> > > on a seperate line directly from my house batteries. That should take
> > > care of any low voltage that might be causeing me trouble. I have 8 gauge
> > > wire up to within 2 feet of it now so will be easy fix.
> > > I appreciate everyone's help.
> > > Dan
> > >
> > > --- In [email protected], "Alan" <alan@> wrote:
> > > >
> > > > Dan you should download the latest OTWinconfig program. It changes when
> > > > new features come out, unfortunately there is no easy way to tell the
> > > > otconfig build. So delete your current one and download. Update your
> > > > firmware using the web update tab in the otWinconfig program.
> > > >
> > > > I don't see any thing obvious, but the no tx on low Voltage could be
> > > > bouncing. Try the config file I uploaded, after downloading the
> > > > otconfig, and updating firmware. Can you check voltage when it
> > > > transmits? It could be resetting from voltage drop, or RF. LEDs flash
> > > > like restart.
> > > > Your GPS is solid, so it's not falsing from weak signals.
> > > >
> > > > Latest OTwinconfig
> > > > https://www.argentdata.com/support/firmware/otwincfg.exe
> > > >
> > > > Hope this helps,
> > > > Alan
> > > >
> > > >
> > > > --- In [email protected], "dan" <wd0afq@> wrote:
> > > > >
> > > > > I guess I should have left it alone. I reset everything and it went
> > > > > back to beaconing every minute. Will yall look at my most recent
> > > > > settings and see if you can see a mistake I have made? I just
> > > > > uploaded my new settings.
> > > > > Thanks,
> > > > > Dan
> > > > >
> > > >
> > >
> >
>
