I have no reason to doubt it. The other pins are as stated in the manual. The rear-panel connector is wired so that it may be connected to a PC using a
standard straight-through serial cable. A null-modem adapter is needed to connect a GPS receiver having a typical serial cable. The pin-out of the d-sub connector is as follows: 2: Data out 3: Data in 5: Ground 6: Profile select 8: 1-wire data bus ----- Original Message ----- From: micalite To: [email protected] Sent: Wednesday, March 10, 2010 10:04 AM Subject: [tracker2] T2-135 profile switching question Can someone confirm that the "jumper" referred to in the profile switching section of the configuration screen is actually pin 6 on the DB9 of the Alinco DR135T rear connector once the T2-135 is installed. Is it appropriate to pull pin 6 to ground as part of the profile selection setup? It appears to be so from the instruction manual of other tracker models, but the T2-135 manual is a little slim on this point. Don't want to let the smoke out! Thanks Terry ------------------------------------------------------------------------------ No virus found in this incoming message. Checked by AVG - www.avg.com Version: 8.5.436 / Virus Database: 271.1.1/2734 - Release Date: 03/10/10 07:33:00
