You had a lot of messed up settings, the one that caused the continuous TX was the profile switch jumper 1 to jumper 1. this will cause a mobius loop of TX. Uncheck all of the profile stuff.
Other stuff: The loooooong TX delay 465ms? set to 18ms (watch out, the CFG program will lower this TXD number every time you look at the other profile. So set to 18 just prior to sending config to OT2). the loooong path, try the recommended mobile path, this works almost everywere. Three hops is usually not needed "wide1-1,wide2-1" I looked at your RAW history and found that you usually need only one hop to get to an I-gate. uncheck all the stuff, with that large payload, many packets will fail. Short position reports are more successful. Send Staus only once every 15 packets, not every time. Position was set to fixed, set to GPS for moving objects. Is your GPS 9600Baud? Set to auto baud, or to your GPS's baud rate. Once you get it working, then you can start playing with additional bells n whistles. Remember that short packet burst will have a much greater success rate. Please try out the 2EOBNS_FIXED config file that I posted to the folders. Make sure your TX deviation is set to a "nice" level. It should sound as loud as a DTMF tone, not blasting, not sub-audible. Cheers, Alan n6vud --- In [email protected], "Andy W in Waterlooville" <adw...@...> wrote: > > hi all, > > Have a problem setting up my OT2m. I have uploaded the config files for the > OT2m and my TinyTrack3+ whicih I have used as a base setting but can't get > the OT2m to stop transmiting every 1.9sec or there abouts. There is also a > screen shot in the photos section. > > Files are > > Config1 for OT2m and Config1 for tinytrack > > Please have a look and see if you can help. If you would like the OT2m > config file then please email me at 2e0...@... and I'll forward it for you to > look at and alter as you determin. > > Andy Wilkinson > Membership Officer > South East Hampshire RAYNET >
