> > It turns out that there are markings on the Australian line cord: > > N/12237 on the Australian plug > N/12239 on the IEC connector. > > These approval numbers are from the "Department of Minerals and Energy", > signifying compliance to part IVC of the Electricity Act of 1945. > > Any comments on the value of that certification? > > _______________________ > Heber Farnsworth P.E. > Physio-Control Agency Compliance Engineer, > Seattle, USA >
Hi Heber: These markings are the CERTIFICATION markings, i.e., they are equivalent to a UL mark here in the USA. Its a bit tricky to decipher the various Oz certification marks as each state has its own mark (which is mutually recognized throughout Oz and NZ). Not only does each state have its own mark, but, I believe, the number is the number appearing on the plug or connector certificate. So, plugs from different manufacturers will have different numbers. It is also possible that plugs from the same manufacturer will have different numbers if they have different certificates. In Australia and New Zealand, plugs, sockets, etc., are "prescribed" items, meaning that they MUST be certified. So, the "value" of these certification marks is that you get to sell your product legally. Without these marks, you run a risk of recall and fine. I suspect there are similar marks on the cordage, as the cordage is separately certified. Best wishes for the New Year, Rich ------------------------------------------------------------- Richard Nute Quality Department Hewlett-Packard Company Product Regulations Group San Diego Division (SDD) Tel : 619 655 3329 16399 West Bernardo Drive FAX : 619 655 4979 San Diego, California 92127 e-mail: [email protected] -------------------------------------------------------------
