> From: Bob Blank <[email protected]>
> Seeking source for shielded power cords to meet
> CE mark requirements.
> Prefer braided shield (80% tinned copper) instead
> of foil 18/3, CEE color coding, 10A, 125 V,
> PVC jacket, 9'10" long should have female
> connector PH-30 (angled IEC 320) molded on
> Should meet any other specs required for CE mark
> Any advice is greatly appreciated
> R. Blank
Bob and emc-pstc,
Been watching the discussion on this and
have to ask these possibly dumb questions:
You are asking for only 1 connector on this
power cord. Not 2. I.e. a power cord with
a detachable connector on the product end,
not the mains end.
(1) Is that correct?
If yes, then
(2) Is this to provide the customer with the freedom
to choose whatever mains side plug they need?
(3) Or, will the wire end be permanently attached
to the mains?
Just wondering that if the answer is (2), then I
can understand the current discussion as to a lack
of control on the replacement cord used being shielded.
No argument with this at all.
But, if the answer is (3), then the power cord will be
permanently installed to the mains and as such will have
to be installed by a licensed electrician per installation
instructions. Thus, no worry that the next power cord
will HAVE to be an equivalent shielded power cable
installed the same way.
Or am I off on some tangent ...
Regards, Doug
