Thanks Carl. I downloaded Eagle and will bear down on learning it. I’ve used AutoCad before so I’m hoping there is a wee bit of familiarity. There should be some good tutorials for it.
Dwight Sent from my iPhone > On Mar 25, 2019, at 10:45 PM, Carl Nobile <[email protected]> wrote: > > So Fritzing is the easiest and KiCad the hardest, the one in the middle is > Eagle. Fritzing is so simple that it may not even be able to do what you > want. However, all these programs takes an investment of time to learn. > > Carl > >> On Mon, Mar 25, 2019, 10:22 PM Dwight Morgan via TriEmbed >> <[email protected]> wrote: >> Hello All, >> >> >> >> I’m trying to get a simple PCB off my bread board and on a PCB. I’ve been >> trying to use Fritzing and KiCad but it gets pretty harry and I’m thinking >> maybe there is a better software. What is a good solid program for a >> beginner with this effort to send files for fabrication? I know the group >> has probably covered this on some level before, but I wasn’t ready to take >> that on at the time. I think I can get it done with one of the programs, I >> just want a little advice. >> >> Thanks for any input. >> >> >> >> Dwight >> >> _______________________________________________ >> Triangle, NC Embedded Computing mailing list >> >> To post message: [email protected] >> List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org >> TriEmbed web site: http://TriEmbed.org >> To unsubscribe, click link and send a blank message: >> mailto:[email protected]?subject=unsubscribe >>
_______________________________________________ Triangle, NC Embedded Computing mailing list To post message: [email protected] List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org TriEmbed web site: http://TriEmbed.org To unsubscribe, click link and send a blank message: mailto:[email protected]?subject=unsubscribe
