I apologize for dumping all of my questions on the list at once but I am stuck in one other place. After setting up spamassassin to work with MailScanner I am working on razor, pyzor, and dcc. I have MailScanner set to use them with the following MailScanner.conf entry:
# paths to utilities pyzor_path /usr/bin/pyzor dcc_path /usr/local/bin/dccproc # Uncomment the lines below to stop using the specific service # To stop Razor2 checks, uncomment the following line # use_razor2 0 # To stop DCC checks, uncomment the following line # use_dcc 0 # To stop Pyzor checks, uncomment the following line # use_pyzor 0 # The timeouts for blacklists and Razor are rather generous in the # default state that SpamAssassin is shipped. Reducing these # stops a lot of timeouts from removing SpamAssassin scores # altogether. rbl_timeout 20 razor_timeout 10 pyzor_timeout 10 I downloaded and installed the rpm's for all three packages from urpmi. The above entries are pretty much the MailScanner defaults. Is this all I have to do? Do I need to set up any auto updating or configure these three packages initially? Please forgive the newbie question but I can't seem to make much sense of the documentation on these three individual packages. Mail is being delivered through the gateway properly so I assume there aren't any configuration issues. Any help would be most appreciated. Thanks again! Douglas Ward Director of Information Technology NC Methodist Conference 1307 Glenwood Ave. Raleigh, NC 27605 Work: (919) 832-9560 ext. 227 Fax: (919) 834-7989 -- TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug TriLUG Organizational FAQ : http://trilug.org/faq/ TriLUG Member Services FAQ : http://members.trilug.org/services_faq/ TriLUG PGP Keyring : http://trilug.org/~chrish/trilug.asc
