I'm having trouble with a Blade. It PXE boots fine into a network
install. The install runs great with the onboard Broadcom NICs. If I
install an expansion card that adds two interfaces, the problems
start. After anaconda starts, the machine issues a DHCP request.
This request isn't being seen by the DHCP server. It just will not
perform this network install with the expansion card in! Any ideas?
I'm passing ksdevice=eth0 during startup.
On some boxes at $JOB, PXE is on the on-mobo interface, but eth0 is the
top dual-port card.
I didn't find a good way to make the mobo have eth0 reliably, so, the
buildout team gets to play cablepluggerinnery games.
--
TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
TriLUG Organizational FAQ : http://trilug.org/faq/
TriLUG Member Services FAQ : http://members.trilug.org/services_faq/
