Hi, I've spent a couple of days fighting with this, so, I hope someone could
lend me a hand...
Abstract:
Tried to use the laptop's wireless card installing its firmware from a
Debian's package; it doesn't work at all; purged that package and removed the
modules, but after reboot the NIC stoped working (but it works if I boot a
LiveUSB of Parabola, just that not as 'eth0' but as 'enp6s0').
This is the actual situation:
root@user:/home/user# lspci
03:00.0 Network controller: Intel Corporation Centrino Wireless-N 1030
[Rainbow Peak] (rev 34)
04:00.0 USB controller: NEC Corporation uPD720200 USB 3.0 Host Controller
(rev 04)
06:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 06)
root@user:/home/user# lshw
user
descripción: Portátil
producto: Dell System XPS L502X (System SKUNumber)
fabricante: Dell Inc.
versión: 0.1
serie: FRSTQQ1
anchura: 64 bits
capacidades: smbios-2.6 dmi-2.6 vsyscall32
configuración: administrator_password=unknown boot=normal
chassis=portable family=HuronRiver System frontpanel_password=unknown
keyboard_password=unknown power-on_password=unknown sku=System SKUNumber
uuid=44454C4C-5200-1053-8054-C6C04F515131
*-network NO RECLAMADO
descripción: Network controller
producto: Centrino Wireless-N 1030 [Rainbow Peak]
fabricante: Intel Corporation
id físico: 0
información del bus: pci@0000:03:00.0
versión: 34
anchura: 64 bits
reloj: 33MHz
capacidades: pm msi pciexpress cap_list
configuración: latency=0
recursos: memoria:f1b00000-f1b01fff
*-network DESACTIVADO
descripción: Ethernet interface
producto: RTL8111/8168/8411 PCI Express Gigabit Ethernet
Controller
fabricante: Realtek Semiconductor Co., Ltd.
id físico: 0
información del bus: pci@0000:06:00.0
nombre lógico: eth0
versión: 06
serie: 14:fe:b5:b8:11:13
tamaño: 1Gbit/s
capacidad: 1Gbit/s
anchura: 64 bits
reloj: 33MHz
capacidades: pm msi pciexpress msix vpd bus_master cap_list
ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd
autonegotiation
configuración: autonegotiation=on broadcast=yes driver=r8169
driverversion=2.3LK-NAPI duplex=full ip=10.0.0.3 latency=0 link=no
multicast=yes port=MII speed=1Gbit/s
recursos: irq:50 ioport:2000(size=256)
memoria:f1804000-f1804fff memoria:f1800000-f1803fff
root@user:/home/user# ifconfig -a
eth0 Link encap:Ethernet direcciónHW 14:fe:b5:b8:11:13
Direc. inet:10.0.0.3 Difus.:10.0.0.255 Másc:255.255.255.0
DIFUSIÓN MULTICAST MTU:1500 Métrica:1
Paquetes RX:0 errores:0 perdidos:0 overruns:0 frame:0
Paquetes TX:0 errores:0 perdidos:0 overruns:0 carrier:0
colisiones:0 long.colaTX:1000
Bytes RX:0 (0.0 B) TX bytes:0 (0.0 B)
lo Link encap:Bucle local
Direc. inet:127.0.0.1 Másc:255.0.0.0
Dirección inet6: ::1/128 Alcance:Anfitrión
ACTIVO BUCLE FUNCIONANDO MTU:65536 Métrica:1
Paquetes RX:4882 errores:0 perdidos:0 overruns:0 frame:0
Paquetes TX:4882 errores:0 perdidos:0 overruns:0 carrier:0
colisiones:0 long.colaTX:0
Bytes RX:398520 (398.5 KB) TX bytes:398520 (398.5 KB)
virbr0 Link encap:Ethernet direcciónHW e6:81:37:a7:6f:32
Direc. inet:192.168.122.1 Difus.:192.168.122.255
Másc:255.255.255.0
ACTIVO DIFUSIÓN MULTICAST MTU:1500 Métrica:1
Paquetes RX:0 errores:0 perdidos:0 overruns:0 frame:0
Paquetes TX:0 errores:0 perdidos:0 overruns:0 carrier:0
colisiones:0 long.colaTX:0
Bytes RX:0 (0.0 B) TX bytes:0 (0.0 B)
root@user:/home/user# iwconfig
eth0 no wireless extensions.
lo no wireless extensions.
virbr0 no wireless extensions.
root@user:/home/user# nmap -sP 10.0.0.*
Starting Nmap 6.40 ( http://nmap.org ) at 2016-12-03 08:55 ART
setup_target: failed to determine route to 10.0.0.0
setup_target: failed to determine route to 10.0.0.1
[...]
setup_target: failed to determine route to 10.0.0.254
setup_target: failed to determine route to 10.0.0.255
mass_dns: warning: Unable to determine any DNS servers. Reverse DNS is
disabled. Try using --system-dns or specify valid servers with --dns-servers
Nmap scan report for 10.0.0.3
Host is up.
Nmap done: 1 IP address (1 host up) scanned in 0.01 seconds
root@user:/home/user# nm-online
Conectando............... 1s
root@user:/home/user# nm-online -x
root@user:/home/user# nm-tool
NetworkManager Tool
State: disconnected
- Device: eth0
-----------------------------------------------------------------
Type: Wired
Driver: r8169
State: unavailable
Default: no
HW Address: 14:FE:B5:B8:11:13
Capabilities:
Carrier Detect: yes
Wired Properties
Carrier: off
The NIC used to work just fine. But now I can't make it connect.
Strangely, if I boot with Parabola's LiveCD, I get:
root@parabolaiso ~ # lspci
03:00.0 Network controller: Intel Corporation Centrino Wireless-N 1030
[Rainbow Peak] (rev 34)
04:00.0 USB controller: NEC Corporation uPD720200 USB 3.0 Host Controller
(rev 04)
06:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 06)
root@parabolaiso ~ # lshw
parabolaiso
description: Portable Computer
product: Dell System XPS L502X (System SKUNumber)
vendor: Dell Inc.
version: 0.1
serial: FRSTQQ1
width: 4294967295 bits
capabilities: smbios-2.6 dmi-2.6 smp vsyscall32
configuration: administrator_password=unknown boot=normal
chassis=portable family=HuronRiver System frontpanel_password=unknown
keyboard_password=unknown power-on_password=unknown sku=System SKUNumber
uuid=44454C4C-5200-1053-8054-C6C04F515131
*-network UNCLAIMED
description: Network controller
product: Centrino Wireless-N 1030 [Rainbow Peak]
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:03:00.0
version: 34
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress cap_list
configuration: latency=0
resources: memory:f1b00000-f1b01fff
*-network
description: Ethernet interface
product: RTL8111/8168/8411 PCI Express Gigabit Ethernet
Controller
vendor: Realtek Semiconductor Co., Ltd.
physical id: 0
bus info: pci@0000:06:00.0
logical name: enp6s0
version: 06
serial: 14:fe:b5:b8:11:13
size: 100Mbit/s
capacity: 1Gbit/s
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress msix vpd bus_master cap_list
ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd
autonegotiation
configuration: autonegotiation=on broadcast=yes driver=r8169
driverversion=2.3LK-NAPI duplex=full ip=10.0.0.3 latency=0 link=yes
multicast=yes port=MII speed=100Mbit/s
resources: irq:25 ioport:2000(size=256)
memory:f1804000-f1804fff memory:f1800000-f1803fff
root@parabolaiso ~ # ifconfig -a
enp6s0: flags=4163 mtu 1500
inet 10.0.0.3 netmask 255.255.255.0 broadcast 10.0.0.255
inet6 fe80::ae8a:4c4c:9fc5:97d1 prefixlen 64 scopeid 0x20
ether 14:fe:b5:b8:11:13 txqueuelen 1000 (Ethernet)
RX packets 221424 bytes 240347192 (229.2 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 174187 bytes 23830144 (22.7 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73 mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10
loop txqueuelen 1 (Local Loopback)
RX packets 64 bytes 3896 (3.8 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 64 bytes 3896 (3.8 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
root@parabolaiso ~ # iwconfig
lo no wireless extensions.
enp6s0 no wireless extensions.
root@parabolaiso ~ # lsmod | grep iwl
iwlwifi 180224 0
cfg80211 495616 1 iwlwifi
root@parabolaiso ~ # lsmod | grep r81
r8169 77824 0
mii 16384 1 r8169
And the NIC works just fine (I'm using it right now) with the same modules,
so: How can I make the NIC work again under Trisquel?
Thanks a lot.
