Dear Michel,
I am afraid that this is not possible in TRNSYS. But there is the
option for TRNSYS to call a program and wait until it finishes the
calculations. You can use the utility subroutine CALLPROGRAM (Volume
8-Programmer's Guide, section 8.4.4.1) for this purpose.
I hope this helps.
Best regards,
Diego
[EMAIL PROTECTED] wrote:
Hello
I'm trying to run TRNSYS from LabVIEW, and I intend to pause TRNSYS
after each simulation timestep until LabVIEW decides that it should
calculate the next timestep. Starting TRNSYS is no problem - it can be
done with a command line call from LabVIEW, but does anyone have an
idea how to tell TRNSYS to pause after every timestep until it get's a
call to go on?
Thanks for helping...
Sonnige Grüsse
Michel Haller
------------------------------------------------------------------------
*Michel Haller*
Systemtechnik / System Division
Institut für Solartechnik SPF: Adresse
<http://www.solarenergy.ch/spf.php?lang=de&fam=44&tab=3> / Website
<http://www.solarenergy.ch/spf.php?lang=de&fam=41&tab=1>
Hochschule für Technik Rapperswil HSR
Tel. +41 55 222 48 29
Fax +41 55 222 48 44
------------------------------------------------------------------------
------------------------------------------------------------------------
_______________________________________________
TRNSYS-users mailing list
[email protected]
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
--
Diego A. Arias
TRNSYS Coordinator
Solar Energy Laboratory
University of Wisconsin - Madison
1500 Engineering Drive
Madison, WI 53706
_______________________________________________
TRNSYS-users mailing list
[email protected]
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
