Dear Mike, This message is created when the outputs from a component that is updated at the end of a time-step. Is it possible that you have connected the output from an integrator as input to another component? If this is not the case, please feel free to contact your distributor; they may be able to help you. Best regards,
Diego mike matheus wrote: > I am creating a project with a PID controller that mixes two air > streams to maintain a set hum. ratio, then heats the air mixture in a > crossflow heat exchanger. The mixing of the air streams is controlled > by the PID and works well as long as the inputs into the heat > exchanger are constant. When I add a pump onto the hot side of the > heat exchanger with varying conditions, the simulation will not run. > I get a series of warnings about (TRNSYS Message 315) connection > sequences. Has anybody else had a similar problem with version 16? > Any ideas on how to fix it? > > Thank you, > > MIke Matheus > > _________________________________________________________________ > Is your PC infected? Get a FREE online computer virus scan from > McAfee® Security. > http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963 > > ------------------------------------------------------------------------ > > _______________________________________________ > TRNSYS-users mailing list > [email protected] > https://www.cae.wisc.edu/mailman/listinfo/trnsys-users > -- Diego A. Arias TRNSYS Coordinator Solar Energy Laboratory University of Wisconsin - Madison 1500 Engineering Drive Madison, WI 53706 _______________________________________________ TRNSYS-users mailing list [email protected] https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
