Fen -
The thing I see right away is that you have a variable name of control_gt in an
equation block. Variable names cannot start with the letters "con".
Regards,
Tim
----------------------------------
Timothy McDowell
Executive Vice President
Thermal Energy System Specialists, LLC
2916 Marketplace Dr, Suite 104
Madison, WI 53719
Phone: 608-274-2577
Fax: 608-278-1475
----- Original Message -----
Subject: [TRNSYS-users] unexpected error with TRNSYS type10
From: [EMAIL PROTECTED]
Date: Tue, August 7, 2007 8:28
Hello TRNSYS users,
We've got a problem with the "type 10 rock bed storage" of Trnsys Simulation
Studio 16. When the segment number is set to more than 13 (in DERIVATIVES ),
we obtain the error message of "Range check error" and then "Unexpected error
was encountered and TRSYS will abort".
It is indicated by the manual of "Input-Output-Parameter" that the valid range
for segment number is 1 to 40. We also checked the source code of TYPE 10, but
failed to find a solution. Do you think it is due to the constrain of input
parameters?
We attched a very simple example to show how it happens. It is highly
appreciated if you can check it and can give us some suggestions.
Thanks and best regards,
Fen
:._______________
_______________________________________________
TRNSYS-users mailing list
[email protected]
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
_______________________________________________
TRNSYS-users mailing list
[email protected]
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users
