Hi,
I?ve created a raid1 software raid with mdadm but can?t bring it to work
automaticaly after a reboot, always have to give the "mdadm --assemble"
command to bring it back online. The box is a Dell PowerEdge 1600 the
system disk is attached to the onboard controller, the raid disks are
attached to an adaptec 29160. During the boot process I can see that md
autodect runs before the adaptec driver is loaded. Later during boot
there is a message "Starting up RAID devices: md0(skipped)".
My /etc/mdadm.conf looks like this:
DEVICE /dev/sda1 /dev/sdb1
ARRAY /dev/md0 level=raid1 devices=/dev/sda1,/dev/sdb1
The mdadm -D -s output when the array is online
ARRAY /dev/md0 level=raid1 num-devices=2
UUID=8b91a217:3fc89e01:40a627ac:8fe19432
devices=/dev/sda1,/dev/sdb1
Any ideas what I?m doing wrong?
Regards,
Mike
_______________________________________________
tsl-discuss mailing list
[email protected]
http://lists.trustix.org/mailman/listinfo/tsl-discuss
