Dear Alberto, I Bilve that whenever I have such problem, I always look at the compatibility side, means I have some doubts about that, first you have to open the Windows compatibility site:
A.Make sure that the model is listed there, I've search there for sometimes and I found allot of error concerning Mylex, second please follow the normal instructions about the RAID installation. http://msdn.microsoft.com/archive/en-us/dnarntpro00/html/RAID.asp B. From your description I thought that this issue can occur because Windows 2000 Plug and Play (PnP) detects both controllers during Setup and then tries to load their corresponding drivers. A resource conflict exists when each driver tries to control the same device on the computer, causing the RAID device configuration information to be lost. Like MS says, check the firmware, I've gone through allot of manuals to read about your problem. Any how. 1. Boot into the Mylex RAID configuration utility by pressing ALT-R when prompted by the Basic Input/Output System (BIOS). 2. Click Perform Administration on..., click Physical Device, and then click the first offline drive. 3. Click Advanced Options, click Make Drive Online, and then click Yes if you receive a warning about data corruption making drive online. 4. Repeat the preceding steps until all drives that were reset by Windows 2000 Setup are back online. C. Have you use the HOT pare here, please try to read page 60 and 67 in this manual: http://www.lsilogic.com/files/docs/marketing_docs/storage_standard_pro d/raid/gam/er_2000_install_guide.pdf Regards ...Amrow... --- In [email protected], "Corrales, Alberto" <[EMAIL PROTECTED]> wrote: > Hello all, > > I�m again asking for help :) . > > > We have a customer which have the problem: > > So a disk fail in mirror configuration (RAID1) we replaced a 36Gb. disk, after this, the disk didn�t begin the rebuild. For this reason, we load from the Mylex controler Bios and tryed to execute the rebuild option BUT it didn�t start. > The replacement disk is the same model and capacity of the other one. > > This was executed a couple of time but doesn�t work. > > We did -under windows 2000- remove and insert the disk but the rebuild neither began. > > The Mylex controller has "Rebuild Auto" enable. > > > Do you have any information or hits for to try resolve this problem? > > Thanks > Alberto ----------------------------- Visit www.tsolver.net Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/tsolver/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
