This is exactly how I have extended Turbine User in my application. I need to go back over it carefully and make sure that I did not make any syntax errors.
A big question that I have is one the solution mentioned at the end. It talks about patching Object.vm to allow addChildObject(obj) to work properly through the extended user object. I am not sure if this is still applicable. -----Original Message----- From: Scott Eade [mailto:[EMAIL PROTECTED]] Sent: Wednesday, December 11, 2002 4:03 AM To: turbine-dev Subject: Re: Updated Extend User How-to > From: "Quinton McCombs" <[EMAIL PROTECTED]> > > I have a patch to update the Extend User How-to for T2.2. I have been > reading posts that the TDK is going away. Should this how-to use > newapp as an example or should I use a different example? The > attached patch does not use the newapp example. I was hoping for some > comments. I believe everything is correct. There could be a few > small errors. > > If the consensus is to use the newapp example, I will change it > appropriately. Quinton, The reason the newapp example was used in the past was so that people could easily experiment with the extend user mechanism on a hopefully familiar application before attempting to apply it to their real and most likely significantly larger projects. While sticking with the newapp example would follow this lead, if the example you have used is easily understandable then people should be able to apply it to newapp or their own project without too much trouble. The most important thing is that the extend user howto document is updated in an accurate and detailed manner. I leave it to others that are up on 2.2 to verify your instructions. Excellent to see some progress on documentation. I only wish Pier would respond to my email messages about setting up the wiki. Cheers, Scott -- Scott Eade Backstage Technologies Pty. Ltd. http://www.backstagetech.com.au -- To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]> For additional commands, e-mail: <mailto:[EMAIL PROTECTED]> -- To unsubscribe, e-mail: <mailto:[EMAIL PROTECTED]> For additional commands, e-mail: <mailto:[EMAIL PROTECTED]>
