On Tue, 11 May 2010 11:00:20 -0700
ramya natarajan <[email protected]> wrote:
> Hello,
>
> I am very beginner to programming, I got task to Write a loop that reads
> each line of a file and counts the number of lines that are read until the
> total length of the lines is 1,000 characters. I have to read lines from
> files exactly upto 1000 characters.
>
> Here is my code:
> I created file under /tmp/new.txt which has 100 lines and 2700 characters
> , I wrote code will read exactly 1000 characters and count lines upto those
> characters.But the problem is its reading entire line and not stopping
> excatly in 1000 characters. Can some one help what mistake i am doing here?.
>
> log = open('/tmp/new.txt','r')
> lines,char = 0,0
> for line in log.readlines():
> while char < 1000 :
> for ch in line :
> char += len(ch)
> lines += 1
> print char , lines
> 1026 , 38 ---- Its counting entire line instead of character upto 1000
> -- can some one point out what mistake am i doing here , where its not
> stopping at 1000 . I am reading only char by car
>
> My new.txt -- cotains content like
> this is my new number\n
>
> Can some one please help. I spent hours and hours to find issue but i am not
> able to figure out, Any help would be greatly appreciated.
> Thank you
> Ramya
Either you read line per line, but then you cannot stop exactly at the 1000th
character; or you traverse the text char per char, but this is a bit picky.
I would read line per line, and when count >= 1000, read chars inside current
line to get to the 1000th, if needed.
(Your specification does not state this, but your disappointment seems to be
about that issue ;-)
Denis
________________________________
vit esse estrany ☣
spir.wikidot.com
_______________________________________________
Tutor maillist - [email protected]
To unsubscribe or change subscription options:
http://mail.python.org/mailman/listinfo/tutor
