Julik is not textdrive sysadmin =) On 1/23/06, Stephen Bannasch <[EMAIL PROTECTED]> wrote: > >Hi, Scott, > > > >Scott Laird wrote: > > > > >1. Is the memory usage fairly constant, or is it growing? There was > > >a memory leak in Rails 0.14.2 (I think) that caused Typo to grow > > >without bound; that leak has been fixed, but there could be other leaks. > > >2. How much memory is Typo using. I keep hearing numbers like > > >"lots", but I've only seen one set of numbers so far. > > > > > > >My own Typo installation is about 50 MB. Very low traffic. It starts > >off at around 30 MB (like my other Rails apps) and then after the first > >page load goes to 50 MB (unlike other RoR apps, which tend to stay > >around 30 MB unless something unusual is going on). The memory usage on > >my installation of Typo doesn't grow much, although that could be > >because of low volume (I've tested with ab, too, but that doesn't prove > >much). It has gone up 2MB since yesterday, when it was steady around 50 MB. > > According to Julik (a textdrive sysadmin) his experience is that most rails > apps take between 20-70MB -- 50MB is right in the middle of this range. > Elsewhere in the posting linked below he talks about minimizing the number of > fcgi listeners. > > http://weblog.textdrive.com/article/175/rails-optimizing-resource-usage > > "A Rails application usually consumes anywhere from 20 to 50-70 Mb per > FastCGI dispatcher. If a Rails application is tuned properly this amount > should stabilize after about 20 requests and stay the same. " > > -- > > -- Stephen Bannasch, stephen at deanbrook dot org > _______________________________________________ > Typo-list mailing list > Typo-list@rubyforge.org > http://rubyforge.org/mailman/listinfo/typo-list >
-- Nikanorov Andrey <[EMAIL PROTECTED]> http://blogru.nikanorov.com This email is: [ ] blogable [ x ] ask first [ ] private _______________________________________________ Typo-list mailing list Typo-list@rubyforge.org http://rubyforge.org/mailman/listinfo/typo-list
