The support found under SYS_FAULT_ECHO_LINK_DOWN requires that the
SYS_FAULT_MII_ADDR symbol also be set. This wasn't previously found in
Kconfig, so add it now.
Signed-off-by: Tom Rini <tr...@konsulko.com>
---
This was found as part of testing "allyesconfig". I'm not sure if
there's anything useful that could be put in the "help" text here.
---
README | 3 ---
net/Kconfig | 4 ++++
2 files changed, 4 insertions(+), 3 deletions(-)
diff --git a/README b/README
index 65305e6a0371..7808af528625 100644
--- a/README
+++ b/README
@@ -1249,9 +1249,6 @@ Note: once the monitor has been relocated, then it will
complain if
the default environment is used; a new CRC is computed as soon as you
use the "saveenv" command to store a valid environment.
-- CONFIG_SYS_FAULT_MII_ADDR:
- MII address of the PHY to check for the Ethernet link state.
-
- CONFIG_DISPLAY_BOARDINFO
Display information about the board that U-Boot is running on
when U-Boot starts up. The board function checkboard() is called
diff --git a/net/Kconfig b/net/Kconfig
index 24508026200d..6d5de9a675e4 100644
--- a/net/Kconfig
+++ b/net/Kconfig
@@ -60,6 +60,10 @@ config SYS_FAULT_ECHO_LINK_DOWN
this option is active, then CONFIG_SYS_FAULT_MII_ADDR also needs to
be configured.
+config SYS_FAULT_MII_ADDR
+ hex "MII address of the PHY to check for the Ethernet link state"
+ depends on SYS_FAULT_ECHO_LINK_DOWN
+
config TFTP_PORT
bool "Set TFTP UDP source/destination ports via the environment"
help
--
2.43.0
