Mahesh, I am not aware of the GW2355 and if it was a custom design since Gateworks does do custom boards. For their current "retail" offerings I had posted a patch a few months ago:
http://article.gmane.org/gmane.comp.boot-loaders.u-boot/30313/match=avila Hope it helps. -Ranjit On 1/18/08 12:46 PM, "Mahesh Kumar" <[EMAIL PROTECTED]> wrote: > Hi, > > Has anybody done the u-boot porting on Avila platforms. I have GW2355, > which is based on IXP425 CPU. > > I have used the existing IXDP425 support from the u-boot, and could get > the console messages till the prompt. But the problem is I could not > write anything in the console. I could see that the serial_getc() is > looping around to get a character in the UART receive buffer. Since the > "data ready bit" is not set, the loop is like a forever type. > > Any idea on this matter ?. > > Thanks in advance. > > Regards, > Mahesh. > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > U-Boot-Users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/u-boot-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
