Peter,
On Tue, Jan 29, 2008 at 05:21:49PM -0000, Peter Pearse wrote:
> Fix at91rm9200dk base address
> is available for test from
> git://linux-arm.org/u-boot-armdev.git#071206_at91_base
>
> AT91RM9200 based boards config cleanup
> is available for test from
> git://linux-arm.org/u-boot-armdev.git#071206_at91_bdinfo
>
> Please confirm that the code builds, and runs on the target board(s)
I always at least build test patches I'm sending to mailing list. I can
clone your tree and verify that you applied my patches correctly, but I
see no point doing so. I believe you did it right. Unfortunately I
cannot run test these patches as I do not have any of board in question.
071206_at91_bdinfo is obvious, there are no functional changes.
071206_at91_base is also obvious. I found that bug while working on
custom board similar to at91rm9200dk and the same fix I needed for my
board should apply to at91rm9200dk as well. Whole point of sending those
patches was to prevent people from copying obsolete and/or buggy stuff.
After all, you can see they are still doing so (two times this week only)
Best regards,
ladis
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
