In message <[EMAIL PROTECTED]> you wrote:
> 
> BDI2000 doesn't support NAND flash programming. However it's possible
> using BDI2000 to load some code to RAM and then run it. This code can do
> practically anything including NAND programming. Does somebody have such
> code for ppc440epx CPU? 
> 
> To that end I could use u-boot itself if I could make it run directly
> from RAM... just to program NAND. However it's not simple thing to do
> for ppc440... but may be somebody has done it?

You can as well use the BDI2000 to program the standard U-Boot image
to NOR flash, boot from NOR and then use U-Boot...

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED]
You said you  didn't  want  to  use  CGI.pm,  but  methinks  you  are
needlessly reinventing the wheel, one spoke at a time. Either you are
masochistic,  or  you  just haven't seen enough of what CGI.pm can do
for you. -- Randal L. Schwartz in <[EMAIL PROTECTED]>

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users

Reply via email to