Hi Ira,
On Tuesday 29 April 2008, Ira Snyder wrote:
> This is my first patch, so any suggestions would be welcome.
Thanks for your contribution. Its actually quite good for the first time. :)
> I have an AMCC Yosemite board, which I recently updated to use the
> recent ARCH=powerpc work from mainline Linux. Without this patch, trying
> to boot from a uImage does not work. The kernel panics while trying to
> parse the device tree blob. Note that a cuImage works fine previous to
> this patch.
>
> Also, I noticed that when I started booting with a uImage and dtb, that
> eth0 had a MAC address of 00:00:00:00:00:00. Adding
> #define CONFIG_HAS_ETH0 1 fixed this issue, by setting the MAC address
> via the eth0addr variable in U-Boot.
This should be "ethaddr" instead of "eth0addr".
> I tested the following setups:
> 1) Old ARCH=ppc 2.6.13 kernel
> 2) New ARCH=powerpc 2.6.26rc0 kernel (cuImage)
> 3) New ARCH=powerpc 2.6.26rc0 kernel (uImage + dtb)
>
> I ran MAKEALL both with and without the patch. The only changes in output
> were a ~20kB increase in image size for the yellowstone and yosemite
> boards.
Thanks. Please find some comments below.
> Thanks for all of the great work.
> Ira
>
> --
>
> From d76d560b1f61126c63320cec18d5b436f4bb10c0 Mon Sep 17 00:00:00 2001
> From: Ira W. Snyder <[EMAIL PROTECTED]>
> Date: Sat, 26 Apr 2008 16:06:26 -0700
> Subject: [PATCH] PPC-44x: Add Open Firmware support to AMCC Yosemite
I find the subject a little misleading. "Open Firmware" support sounds a
little too much. How about:
"ppc4xx: Add device tree support to AMCC Yosemite"
> Add support for booting with a device tree blob. This is needed to boot
> ARCH=powerpc kernels. Also add support for setting the eth0 mac address
> via the eth0addr variable.
"ethaddr".
> Signed-off-by: Ira W. Snyder <[EMAIL PROTECTED]>
> ---
> board/amcc/yosemite/yosemite.c | 11 +++++++++++
> include/configs/yosemite.h | 9 +++++++++
> 2 files changed, 20 insertions(+), 0 deletions(-)
>
> diff --git a/board/amcc/yosemite/yosemite.c
> b/board/amcc/yosemite/yosemite.c index 6ec922a..fa610c3 100644
> --- a/board/amcc/yosemite/yosemite.c
> +++ b/board/amcc/yosemite/yosemite.c
> @@ -26,6 +26,9 @@
> #include <asm/processor.h>
> #include <asm/io.h>
> #include <spd_sdram.h>
> +#if defined(CONFIG_OF_LIBFDT)
> + #include <libfdt.h>
> +#endif
Please add this header unconditionally (without indentation).
> DECLARE_GLOBAL_DATA_PTR;
>
> @@ -554,3 +557,11 @@ void board_reset(void)
> /* give reset to BCSR */
> *(unsigned char *)(CFG_BCSR_BASE | 0x06) = 0x09;
> }
> +
> +#if defined(CONFIG_OF_BOARD_SETUP)
> +void ft_board_setup(void *blob, bd_t *bd)
> +{
> + ft_cpu_setup(blob, bd);
> +
Why didn't you add the NOR FLASH mapping fixup as done on Sequoia etc? Please
add it here.
> +}
> +#endif
> diff --git a/include/configs/yosemite.h b/include/configs/yosemite.h
> index c9323f6..7dcd4e6 100644
> --- a/include/configs/yosemite.h
> +++ b/include/configs/yosemite.h
> @@ -141,6 +141,14 @@
>
>
> /*-----------------------------------------------------------------------
> + * Open Firmware (Linux-2.6.26+)
I would prefer "Device tree support" here too.
> + *----------------------------------------------------------------------*/
> +
> +/* pass open firmware flat tree */
> +#define CONFIG_OF_LIBFDT 1
> +#define CONFIG_OF_BOARD_SETUP 1
> +
> +/*-----------------------------------------------------------------------
> * I2C
> *----------------------------------------------------------------------*/
> #define CONFIG_HARD_I2C 1 /* I2C with hardware
> support */
> @@ -227,6 +235,7 @@
> #define CONFIG_MII 1 /* MII PHY management */
> #define CONFIG_NET_MULTI 1 /* required for netconsole */
> #define CONFIG_PHY1_ADDR 3
> +#define CONFIG_HAS_ETH0 1 /* add support for "eth0addr"
> */
> #define CONFIG_HAS_ETH1 1 /* add support for "eth1addr"
> */
> #define CONFIG_PHY_ADDR 1 /* PHY address, See schematics
> */
Please address the issues above and resend.
Thanks.
Best regards,
Stefan
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED]
=====================================================================
-------------------------------------------------------------------------
This SF.net email is sponsored by the 2008 JavaOne(SM) Conference
Don't miss this year's exciting event. There's still time to save $100.
Use priority code J8TL2D2.
http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
