On Wed, 14 May 2008, Jens Gehrlein wrote: > Apart from that, verify that your console= > > command line parameter is correct, your machine ID matches, and that you > > don't have a jtag debugger like bdi2000 connected when you're trying to > > boot. > > I have the same problem on our board: I don't see the console outputs if the > BDI2000 cable is connected to the target, although the BDI is in mode "reset > run". Do have an idea why?
No, I don't know "why", but that's exactly why I've mentioned it above - I had the same problem here and I spent about half a day trying to figure out why it didn't boot. Thanks Guennadi --- Guennadi Liakhovetski ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
