On 03:36 Sat 24 May , Sergey Lapin wrote: > Hi, all! > > I use the following patch on my AT91SAM9260-based custom board to > configure bit-banged I2C: > > diff --git a/board/atmel/at91sam9260ek/at91sam9260ek.c > b/board/atmel/at91sam9260ek/at91sam9260ek.c > index b30aad8..99fc2bd 100644 > --- a/board/atmel/at91sam9260ek/at91sam9260ek.c > +++ b/board/atmel/at91sam9260ek/at91sam9260ek.c > @ -234,3 +234,46 @@ void reset_phy(void) > #endif > } > #endif Why don't you use the gpio function? > + void at91sam9260_i2c_init(void) { at91_set_GPIO_periph(AT91_PIN_PA23, 0); at91_set_multi_drive(AT91_PIN_PA23, 1);
at91_set_A_periph(AT91_PIN_PA24, 0); at91_set_multi_drive(AT91_PIN_PA24, 1); } void at91sam9260_i2c_scl(unsigned long bit) { at91_set_gpio_value(AT91_PIN_PA24, bit); } void at91sam9260_i2c_sda(unsigned long bit) { at91_set_gpio_value(AT91_PIN_PA23, bit) } int at91sam9260_i2c_read(void) { retrun at91_get_gpio_value(AT91_PIN_PA23); } void at91sam9260_i2c_active() { gpio_direction_output(AT91_PIN_PA23, 0); } void at91sam9260_i2c_tristate() { gpio_direction_input(AT91_PIN_PA23); } > diff --git a/include/configs/at91sam9260ek.h b/include/configs/at91sam9260ek.h > index fd9932f..5e66c9e 100644 > --- a/include/configs/at91sam9260ek.h > +++ b/include/configs/at91sam9260ek.h > @@ -85,6 +85,8 @@ > > #define CONFIG_CMD_NAND 1 > #define CONFIG_CMD_USB 1 > +#define CONFIG_CMD_I2C 1 > +#define CONFIG_I2C_CMD_TREE 1 > > /* SDRAM */ > #define CONFIG_NR_DRAM_BANKS 1 > @ -192,4 +194,20 @@ > #error CONFIG_USE_IRQ not supported > #endif > > +/* > + * Software (bit-bang) I2C driver configuration > + */ > +#define CONFIG_SOFT_I2C 1 > +#define CFG_I2C_SPEED 1000000 > +#define I2C_INIT at91sam9260_i2c_init() #define I2C_ACTIVE at91sam9260_i2c_active() #define I2C_TRISTATE at91sam9260_i2c_tristate() > +#define I2C_SCL(bit) at91sam9260_i2c_scl(bit) > +#define I2C_SDA(bit) at91sam9260_i2c_sda(bit) > +#define I2C_DELAY udelay(2) > +#define I2C_READ at91sam9260_i2c_read() > +#define CFG_I2C_SLAVE 0 > +#define DEBUG_I2C > #endif > + I sync it will be better to use the hardware stack which is not too complicate to implement Best Regards, J. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users