Signed-off-by: Martha Marx <[EMAIL PROTECTED]>
---
 Makefile                  |    9 ++++-----
 board/ads5121/README      |    9 +++++++++
 board/ads5121/ads5121.c   |   19 +++++++++++++++++--
 cpu/mpc512x/cpu.c         |    8 ++++++--
 include/configs/ads5121.h |   38 +++++++++++++++++++++++++++++++-------
 5 files changed, 67 insertions(+), 16 deletions(-)
 create mode 100644 board/ads5121/README

diff --git a/Makefile b/Makefile
index 3401203..c102b55 100644
--- a/Makefile
+++ b/Makefile
@@ -746,12 +746,11 @@ motionpro_config: unconfig
 ## MPC512x Systems
 #########################################################################
 ads5121_config \
-ads5121_PCI_config \
-       :                unconfig
+ads5121_rev2_config    \
+       : unconfig
        @mkdir -p $(obj)include
-       @if [ "$(findstring _PCI_,$@)" ] ; then \
-               echo "#define CONFIG_PCI"  >>$(obj)include/config.h ; \
-               $(XECHO) "... with PCI enabled" ; \
+       @if [ "$(findstring rev2,$@)" ] ; then \
+               echo "#define CONFIG_ADS5121_REV2 1" > $(obj)include/config.h; \
        fi
        @$(MKCONFIG) -a ads5121 ppc mpc512x ads5121
 
diff --git a/board/ads5121/README b/board/ads5121/README
new file mode 100644
index 0000000..c5a92e8
--- /dev/null
+++ b/board/ads5121/README
@@ -0,0 +1,9 @@
+To configure for the current (Rev 3.x) ADS5121 
+       make ads5121_config
+This will automatically include PCI, the Real Time CLock, add backup flash 
+ability and set the correct frequency and memory configuration.
+
+To configure for the older Rev 2 ADS5121 type (this will not have PCI)
+       make ads5121_rev2_config
+
+
diff --git a/board/ads5121/ads5121.c b/board/ads5121/ads5121.c
index 2892665..95559ca 100644
--- a/board/ads5121/ads5121.c
+++ b/board/ads5121/ads5121.c
@@ -26,7 +26,9 @@
 #include <asm/bitops.h>
 #include <command.h>
 #include <fdt_support.h>
-
+#ifdef CONFIG_MISC_INIT_R
+#include <i2c.h>
+#endif
 /* Clocks in use */
 #define SCCR1_CLOCKS_EN        (CLOCK_SCCR1_CFG_EN |                           
\
                         CLOCK_SCCR1_LPC_EN |                           \
@@ -91,8 +93,21 @@ int board_early_init_f (void)
         * Without this the flash identification routine fails, as it needs to 
issue
         * write commands in order to establish the device ID.
         */
-       *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
 
+#ifdef CONFIG_ADS5121_REV2
+       *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
+#else
+       if (*((u8 *)(CFG_CPLD_BASE + 0x08)) & 0x04) {
+               *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0xC1;
+       } else {
+               /* running from Backup flash */
+               *((volatile u8 *)(CFG_CPLD_BASE + 0x08)) = 0x32;
+       }
+#endif
+       /*
+        * Configure Flash Speed
+        */
+       *((volatile u32 *)(CFG_IMMR + LPC_OFFSET + CS0_CONFIG)) = CFG_CS0_CFG;
        /*
         * Enable clocks
         */
diff --git a/cpu/mpc512x/cpu.c b/cpu/mpc512x/cpu.c
index bed77ac..b59f36d 100644
--- a/cpu/mpc512x/cpu.c
+++ b/cpu/mpc512x/cpu.c
@@ -133,8 +133,9 @@ void watchdog_reset (void)
 #ifdef CONFIG_OF_LIBFDT
 void ft_cpu_setup(void *blob, bd_t *bd)
 {
-       char * cpu_path = "/cpus/" OF_CPU;
-       char * eth_path = "/" OF_SOC "/[EMAIL PROTECTED]";
+       char *cpu_path = "/cpus/" OF_CPU;
+       char *eth_path = "/" OF_SOC "/[EMAIL PROTECTED]";
+       char *eth_path_old = "/" OF_SOC_OLD "/[EMAIL PROTECTED]";
 
        do_fixup_by_path_u32(blob, cpu_path, "timebase-frequency", OF_TBCLK, 1);
        do_fixup_by_path_u32(blob, cpu_path, "bus-frequency", bd->bi_busfreq, 
1);
@@ -144,5 +145,8 @@ void ft_cpu_setup(void *blob, bd_t *bd)
 
        /* this is so old kernels with old device trees will boot */
        do_fixup_by_path_u32(blob, "/" OF_SOC_OLD, "bus-frequency", 
bd->bi_ipsfreq, 0);
+       do_fixup_by_path(blob, eth_path_old, "local-mac-address",
+                       bd->bi_enetaddr, 6, 0);
+       do_fixup_by_path(blob, eth_path_old, "address", bd->bi_enetaddr, 6, 0);
 }
 #endif
diff --git a/include/configs/ads5121.h b/include/configs/ads5121.h
index c975a24..21374e9 100644
--- a/include/configs/ads5121.h
+++ b/include/configs/ads5121.h
@@ -57,7 +57,12 @@
 
 /* CONFIG_PCI is defined at config time */
 
+#ifdef CONFIG_ADS5121_REV2
 #define CFG_MPC512X_CLKIN      66000000        /* in Hz */
+#else
+#define CFG_MPC512X_CLKIN      33333333        /* in Hz */
+#define CONFIG_PCI
+#endif
 
 #define CONFIG_BOARD_EARLY_INIT_F              /* call board_early_init_f() */
 #define CONFIG_MISC_INIT_R
@@ -71,7 +76,11 @@
 /*
  * DDR Setup - manually set all parameters as there's no SPD etc.
  */
+#ifdef CONFIG_ADS5121_REV2
 #define CFG_DDR_SIZE           256             /* MB */
+#else
+#define CFG_DDR_SIZE           512             /* MB */
+#endif
 #define CFG_DDR_BASE           0x00000000      /* DDR is system memory*/
 #define CFG_SDRAM_BASE         CFG_DDR_BASE
 
@@ -119,14 +128,20 @@
  *     [09:05] DRAM tRP:
  *     [04:00] DRAM tRPA
  */
-
+#ifdef CONFIG_ADS5121_REV2
 #define CFG_MDDRC_SYS_CFG      0xF8604A00
 #define CFG_MDDRC_SYS_CFG_RUN  0xE8604A00
+#define CFG_MDDRC_TIME_CFG1    0x54EC1168
+#define CFG_MDDRC_TIME_CFG2    0x35210864
+#else
+#define CFG_MDDRC_SYS_CFG       0xFA804A00
+#define CFG_MDDRC_SYS_CFG_RUN   0xEA804A00
+#define CFG_MDDRC_TIME_CFG1     0x68EC1168
+#define CFG_MDDRC_TIME_CFG2     0x34310864
+#endif
 #define CFG_MDDRC_SYS_CFG_EN   0xF0000000
 #define CFG_MDDRC_TIME_CFG0    0x00003D2E
 #define CFG_MDDRC_TIME_CFG0_RUN        0x06183D2E
-#define CFG_MDDRC_TIME_CFG1    0x54EC1168
-#define CFG_MDDRC_TIME_CFG2    0x35210864
 
 #define CFG_MICRON_NOP         0x01380000
 #define CFG_MICRON_PCHG_ALL    0x01100400
@@ -165,12 +180,17 @@
 /*
  * NOR FLASH on the Local Bus
  */
+#undef CONFIG_BKUP_FLASH
 #define CFG_FLASH_CFI                          /* use the Common Flash 
Interface */
 #define CFG_FLASH_CFI_DRIVER                   /* use the CFI driver */
+#ifdef CONFIG_BKUP_FLASH
+#define CFG_FLASH_BASE         0xFF800000      /* start of FLASH   */
+#define CFG_FLASH_SIZE         0x00800000      /* max flash size in bytes */
+#else
 #define CFG_FLASH_BASE         0xFC000000      /* start of FLASH   */
 #define CFG_FLASH_SIZE         0x04000000      /* max flash size in bytes */
+#endif
 #define CFG_FLASH_USE_BUFFER_WRITE
-
 #define CFG_MAX_FLASH_BANKS    1               /* number of banks */
 #define CFG_FLASH_BANKS_LIST   {CFG_FLASH_BASE}
 #define CFG_MAX_FLASH_SECT     256             /* max sectors per device */
@@ -286,14 +306,13 @@
 #define CONFIG_NET_MULTI
 #define CONFIG_PHY_ADDR                0x1
 #define CONFIG_MII             1       /* MII PHY management           */
+#define CONFIG_FEC_AN_TIMEOUT  1
 
-#if 0
 /*
  * Configure on-board RTC
  */
-#define CONFIG_RTC_DS1374                      /* use ds1374 rtc via i2c       
*/
+#define CONFIG_RTC_M41T62                      /* use M41T62 rtc via i2 */
 #define CFG_I2C_RTC_ADDR               0x68    /* at address 0x68              
*/
-#endif
 
 /*
  * Environment
@@ -302,7 +321,11 @@
 /* This has to be a multiple of the Flash sector size */
 #define CFG_ENV_ADDR           (CFG_MONITOR_BASE + CFG_MONITOR_LEN)
 #define CFG_ENV_SIZE           0x2000
+#ifdef CONFIG_BKUP_FLASH
+#define CFG_ENV_SECT_SIZE      0x20000 /* one sector (256K) for env */
+#else
 #define CFG_ENV_SECT_SIZE      0x40000 /* one sector (256K) for env */
+#endif
 
 /* Address and size of Redundant Environment Sector    */
 #define CFG_ENV_ADDR_REDUND    (CFG_ENV_ADDR + CFG_ENV_SECT_SIZE)
@@ -321,6 +344,7 @@
 #define CONFIG_CMD_PING
 #define CONFIG_CMD_REGINFO
 #define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_DATE
 
 #if defined(CONFIG_PCI)
 #define CONFIG_CMD_PCI
-- 
1.5.2.4


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/u-boot-users

Reply via email to