Hi all,
When u-boot is loaded on board following messages come on my board.
U-Boot 1.3.3 (Jul 2 2008 - 10:34:34)
DRAM: 256 MB
ERROR: too many flash sectors
Flash: 64 MB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
$
If I don't press any key, within 1 minute above things repeat on hyper
terminal again. Actually till user doesn't press anything, above messages
should not repeat on hyper terminal.
Kindly note that
1) CONFIG_BOOTDELAY -1
And none of the below #defines are enabled
CONFIG_BOOT_RETRY_TIME
CONFIG_BOOT_RETRY_MIN
CONFIG_AUTOBOOT_KEYED
CONFIG_AUTOBOOT_PROMPT
CONFIG_AUTOBOOT_DELAY_STR
CONFIG_AUTOBOOT_STOP_STR
CONFIG_AUTOBOOT_DELAY_STR2
CONFIG_AUTOBOOT_STOP_STR2
CONFIG_ZERO_BOOTDELAY_CHECK
CONFIG_RESET_TO_RETRY
--
Regards,
Naveen
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
