Hi
I am using a MPC8349 based board. I have ported the U-boot-1.3.2. When i
transfer some files using the TFTP command the board hangs. Please find
the attached console output. However if i enable ET_DEBUG its getting
through and also tftp transfer is successful from the kernel. Are there
any fixes available for TSEC.
Regards,
R.S.Shree Ram
GDA Technologies,
L&T infotech Park,
Mt.Ponamalle Road,
Manapakkam,
Chennai-600089
U-Boot 1.3.2-g53aaa00b-dirty (Jun 27 2008 - 11:00:52)
MPC83XX
Reset Status:
CPU: e300c1, MPC8349E, Rev: 31 at 528 MHz, CSB:
264 MHz
Board: ATCA_OLT
UPMA: Configured for Teknovus OLT
I2C: ready
DRAM: 256 MB (DDR2, 64-bit, ECC off)
FLASH: 8 MB
In: serial
Out: serial
Err: serial
Net: TSEC0, TSEC1
Type "run flash_nfs" to mount root filesystem over
NFS
Hit any key to stop autoboot: 0
atcaolt=>
atcaolt=> setenv ipaddr 172.29.38.217
atcaolt=> ping 172.29.38.1
Speed: 100, full duplex
Using TSEC0 device
host 172.29.38.1 is alive
atcaolt=> tftp 0x200000 tmrnd/u-boot.bin
Speed: 100, full duplex
Using TSEC0 device
TFTP from server 172.29.38.7; our IP address is
172.29.38.217
Filename 'tmrnd/u-boot.bin'.
Load address: 0x200000
Loading: ##############
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
