Hi, 2008/7/3 navin karnam <[EMAIL PROTECTED]>: > Hi all, > > > I ported u-boot-1.3.3 on board, when boot the board iam getting messagesas > below. What do you use archtechture?
<snip> > > But when try erasing flash : > #erase all > Erase Flash Bank # 1 - Warning: 259 protected sectors will not be erased! > done > > So i enabled the flash for writing using: > #protect off all > Un-Protect Flash Bank # 1 > > After that also i am unable erase the flash: > #erase all > --------------------------------------------------- > Flash erase error at address 680000 > Block Erase Error. > Block locked. I think you failed flash protect off. Please check protect infomation by flinfo command after protect off. When protection is not excluded, setting of Flash may be wrong. <snip> > --------------------------------------------------------------------------------------- > > So how do i erase or write into flash, do i need to write my code which > should do erase and writting into flash? or > The code in u-boot is sufficient to that? Best regards, Nobuhiro ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
